Posted by gtk on Monday, March 19, 2001 at 11:53AM :
In Reply to: Is there any way to repair pitted axle shaft? posted by Tim Way on Monday, March 19, 2001 at 11:13AM :
Have you talked to your machinist about using a seal saver or speed sleeves ? They are thin sleeves pressed over the machined area. Another approach is to braze in some material then machine down to the correct size. I have done this on front crank hubs (before we had speed sleeves) and it works great.
Follow Ups:
This board is powered by the Mr. Fong Device from Cyberarmy.com |