Re: 230 Timing: can't get it lower then +10

Posted by Robert Kosusnik [66.230.118.42] on Monday, September 30, 2013 at 00:01:13 :

In Reply to: 230 Timing: can't get it lower then +10 posted by don in nh [96.61.72.163] on Sunday, September 29, 2013 at 21:52:11 :

Sounds to me that you are forgetting the second adjusting screw, the one that's under the distributor. If I remember right, it's located around the 3 o'clock position as you are looking down at it.
Robert

Follow Ups:

• Bingo, might have to pull dist to get to it. - Chriscase 08:56:53 09/30/2013
  • Re: Can't forget what you never knew... - don in nh 11:30:54 09/30/2013
    • Similar to the one you been using, but upside not down.. - Chris Case 15:03:10 09/30/2013
      • Re: Similar to the one you been using, but upside not down.. - don in nh 16:31:21 09/30/2013
        • Re: Similar to the one you been using, but upside not down.. - gmharris 18:31:18 09/30/2013
          • Re: Are TDC on #1 and #6 at the same angle (0 deg)? - don in nh 09:35:30 10/01/2013
    • Re: Can't forget what you never knew... - Robert Kosusnik 13:13:45 09/30/2013

Post a Followup