Posted by Vaughn on Tuesday, May 22, 2001 at 11:59PM :
In Reply to: How to: Plastigage a mainbearing? posted by Tom in Boise on Tuesday, May 22, 2001 at 11:54PM :
Cut a piece long enough to lay across the journal. Put your cap on and torque to specs, then remove cap and compare to the scale. You can buy shim stock to and place under the bearings between cap to bring them into specs if needed (.001, .002 etc sizes.)
Follow Ups:
This board is powered by the Mr. Fong Device from Cyberarmy.com |