Re: Some indepth info

Posted by Ken C. (VA) [67.187.5.98] on Tuesday, March 29, 2011 at 20:41:41 :

In Reply to: Some indepth info posted by Paul (in NY) [12.64.108.214] on Tuesday, March 29, 2011 at 20:09:33 :

Hey Paul, I'm using PPG DP50-LF Epoxy Primer on my Road Runner (used it in the interior and engine bay - but followed with single-stage color - good results) and am at the point of filler and 1st block sanding on the exterior for a color/clear application.

Have you ever done any block sanding with Epoxy Primer? I'm assuming that I can keep shooting Epoxy after sanding until I get it straight, then scuff it for the Surfacer application. What steps have you had success with on your PPG applications?

Thanks,

Ken C.
'64 W200
'69 Road Runner

Follow Ups:

• Re: Some indepth info - Kevin in Ohio 02:45:24 03/30/2011
  • Re: Some indepth info - Ken C. 20:16:14 03/30/2011
• Re: Some indepth info - Paul (in NY) 21:19:37 03/29/2011
  • Re: Some indepth info - Ken C. 20:19:17 03/30/2011
    • Your Welcome...ntxt - Paul (in NY) 20:51:38 03/30/2011
• Re: Some indepth info - Todd Wilson 21:14:35 03/29/2011
  • Re: Some indepth info - Ken C. 20:23:13 03/30/2011
    • Re: Just a recommendation.... - chrisnj 21:31:57 03/30/2011
      • Re: Just a recommendation.... - Ken C. (VA) 19:37:29 03/31/2011
        • Re: Just a recommendation.... - chrisnj 05:55:18 04/01/2011
      • Re: Just a recommendation.... - chrisnj 21:36:43 03/30/2011

Post a Followup