|
|
Posted by Tom Petroff (IL) [64.12.116.76] on Wednesday, August 26, 2009 at 17:38:22 :
In Reply to: Locking a front hub lock nut posted by Mark in NJ [151.198.55.111] on Wednesday, August 26, 2009 at 17:12:02 :
Mark,
The first nut to go on after the bearing,
Is the nut with the pin on the face.
After you adjust the bearing,you move the nut back just enough to line up with a hole in the lock washer,with the tab in the spindle grove.
Also if you flip the washer over it changes the hole location a little.
Then install and tighten the outer nut securely.
Hope this helps and make more sense.
TGP
Follow Ups: