Re: Centered rear drive shaft?!!

Posted by Paul (in NY) on Tuesday, April 17, 2007 at 19:14:49 :

In Reply to: Centered rear drive shaft?!! posted by Ron M. in AB on Tuesday, April 17, 2007 at 18:27:26 :

I dont know if the stock Ebrake could be 'simply' moved to the outside rear output of the T Case. Look at the pictures of the T Case and you will see that the E Brake Support Bracket bolts onto the bearing retainer. I cant get to the shop tonight to take a peek, but I 'think' the bolt pattern is entirely different between the two output bearing retainers.

Or, you could totally discard the present Stock Ebrake and fab a Disk Ebrake as I do on my Cummins Conversions. Go to the link below to see the MB-2 Caliper that I use. Also browse the site for the ratchet brake handle they sell. I fab my rotors from .375" plate.

Paul

• MB-2 Caliper

Follow Ups:

• Re: Centered rear drive shaft?!! - Jerry in Idaho 21:01:03 04/17/2007
  • Jerry - Paul (in NY) 22:07:50 04/17/2007
    • Re: Jerry - Jerry in Idaho 22:19:04 04/17/2007
      • Re: Jerry - MoparNorm 04:13:00 04/18/2007
• Re: Centered rear drive shaft?!! - Paul (in NY) 19:23:06 04/17/2007
  • Re: Centered rear drive shaft?!! - Ron M. in AB 19:56:37 04/17/2007
    • Ron - Paul (in NY) 20:42:09 04/17/2007
      • Re: Ron - Ron M. in AB 21:20:08 04/17/2007
        • Re: Ron - Paul (in NY) 22:10:18 04/17/2007
          • Re: Ron - Ron M. in AB 23:09:55 04/17/2007
            • Re: Ron - Paul (in NY) 14:19:53 04/18/2007
            • Re: Ron - Jerry in Idaho 01:42:02 04/18/2007
              • further consideration - Jerry in Idaho 18:26:44 04/18/2007
                • Re: further consideration - MoparNorm 12:35:19 04/21/2007
              • Re: Ron - Ron M. in AB 09:55:49 04/18/2007
                • Re: Ron - Jerry in Idaho 10:42:17 04/18/2007
                  • Re: Ron - Ron M. in AB 11:00:45 04/18/2007

Post a Followup