Can anyone machine me a pilot bushing?

Posted by Jonas on Saturday, January 28, 2006 at 6:52PM :

Need one for a Spicer 3053. OD=.988 ID=.745

Thanks for any help.

Jonas

Follow Ups:

• Yet another thought re pilot bearing - chriscase@sbcglobal.com 5:11PM 01/29/2006
  • Watch those bearings - David Sherman 8:25PM 01/29/2006
    • Most bearings are metric, always try to convert to even mm - chriscase@sbcglobal.com 9:36PM 01/29/2006
• 1"x1"x 3/4? look in the yellow bins at Ace hdware? - chriscase@sbcglobal.com 0:31AM 01/29/2006
  • I need .988 x .745 - Jonas 1:17AM 01/29/2006
    • Those are shaft sizes - chriscase@sbcglobal.com 9:59AM 01/29/2006
• Re: Can anyone machine me a pilot bushing? - David Sherman 9:09PM 01/28/2006
  • Re: Can anyone machine me a pilot bushing? - Jonas 9:48PM 01/28/2006
    • Re: Can anyone machine me a pilot bushing? - David Sherman 0:46AM 01/29/2006
      • HaHaHa!!! Caught me! - Jonas 1:13AM 01/29/2006
        • Use one part instead of two.... - Gordon Maney 8:43AM 01/29/2006
          • Re: Use one part instead of two.... - Tom Petroff 9:37AM 01/29/2006
            • I'll hold off on making it until you decide - David Sherman 4:15PM 01/29/2006
              • An alternative - Gordon Maney 8:40PM 01/29/2006
                • Re: An alternative - Jonas 10:18AM 01/30/2006
                  • The goal of repair machining - Gordon Maney 1:48PM 01/30/2006
• Re: Can anyone machine me a pilot bushing? - Spence 8:45PM 01/28/2006

Post a Followup