Budd Wheel Bolt pattern and counter sink info needed

Posted by Will (in MI) on Monday, August 15, 2005 at 11:45AM :

I'm going to have a set of wheels built, and I need to make sure I have the wheel mounting info correct.

I'm not on "my" computer so some of my ref. sites are not available, but need the following:

Bolt Circle Size
Bolt Hole Size
Counter sink info (angle/depth)
Center Hub Size
(Any thing I missed?)

I believe the Bubb wheel is 5 on 6-7/8"

Thanks,
Will

Follow Ups:

• Here's what I got... - chriscase 6:19PM 08/15/2005
  • Thanks Chris, Here's what I got... - Will (in MI) 10:45PM 08/15/2005
    • Little more... - chriscase 11:30PM 08/15/2005
      • One thing to remember... - MoparNorm 11:44PM 08/16/2005
• Re: suggestion ship hub/drum/wheel to builder - COTM Mike Stone (Idaho, USA) 12:00PM 08/15/2005
  • Re: suggestion ship hub/drum/wheel to builder - Will (in MI) 12:10PM 08/15/2005
    • Re: where is your wheel builder located? - COTM Mike Stone (Idaho, USA) 6:42PM 08/15/2005
      • North West Arkansas - Will (in MI) 7:20PM 08/15/2005
    • Why 17"? - Jonas 6:38PM 08/15/2005
      • Re: Why 17"? - Will (in MI) 7:18PM 08/15/2005
        • my last comment on this subject - COTM Mike Stone (Idaho, USA) 9:01PM 08/15/2005
          • Thanks Mike. - Will (in MI) 9:17PM 08/15/2005
      • Re: Why 17"??? - COTM Mike Stone (Idaho, USA) 7:13PM 08/15/2005
    • Re: suggestion ship hub/drum/wheel to builder - COTM Mike Stone (Idaho, USA) 1:00PM 08/15/2005
      • Re: suggestion ship hub/drum/wheel to builder - Will (in MI) 7:16PM 08/15/2005
        • Re: that might be too much - COTM Mike Stone (Idaho, USA) 8:42PM 08/15/2005
      • Re:a 17 inch drop might not clear the drum - COTM Mike Stone (Idaho, USA) 2:47PM 08/15/2005

Post a Followup