Gauge wiring problems... still

Posted by Ammo [162.158.74.30] on Thursday, September 06, 2018 at 18:06:03 :

I started a thread on the last forum regarding my "painless" wiring block and getting my AMP, fuel, and temp gauges working. I tried Keith's suggestion but still nothing.

Here's what I have going on:

10ga wire from voltage regulator "batt" to Amp meter "GA" post. I then have a 10ga wire going from AMP "SW" to my fuse block (Dash B+). I have the respected component feeds attached to the "SW" post for their gauge. Then have 10ga jumper wires, from the AMP "GA" post to each components "GA" post.

Turned on ignition key and got no power to the gauge cluster. Thought o.k., cant run motor because oil pressure line is disconnected so ran a jumper wire from the IGN to the "SW" post of the MP meter for power. Gauges still do nothing.

Can you think of anything I'm missing here? Looking back, I would have never put in that fuse block if I knew how much time I would spend doing so.

Thanks again for everyone help.

ANdy

Follow Ups:

• Re: Gauge wiring problems... still - Desoto61 05:55:23 09/07/2018
• from Google search - Jerry Henry 00:34:59 09/07/2018
• Re: Gauge wiring problems... still - Keith in Washington 19:21:56 09/06/2018
  • Re: Gauge wiring problems... still - Ammo 21:12:57 09/06/2018
• FIXED! I think - Ammo 19:07:57 09/06/2018
  • Re: FIXED! I think - Kaegi 18:01:13 09/07/2018
  • Re: FIXED! I think - Jerry Henry 20:17:30 09/06/2018
• Re: Gauge wiring problems... still - Ammo 18:26:01 09/06/2018
  • Re: Gauge wiring problems... still - Jerry Henry 18:31:30 09/06/2018

Post a Followup