Posted by Ammo [162.158.75.37] on Thursday, September 06, 2018 at 21:12:57 :
In Reply to: Re: Gauge wiring problems... still posted by Keith in Washington [108.162.246.8] on Thursday, September 06, 2018 at 19:21:56 :
Thanks for the feedback Keith.
I'm a little confused that the instructions say to "attach the wire going to the positive battery post or starter solenoid to the "BATT FEED" terminal." I have the wire coming straight from the battery to the BATT FEED terminal at the moment. You say I should run that terminal from the AMP meter?
Ill change my setup and run the gauges off the Dash B+ instead of the accessory side of the ignition switch (that makes sense). The IGN and Coil are wired up as per the instructions. The only issue I'm facing with the coil is mine is a pertronix electronic ignition system and I cant leave the key on, without the engine running, or I risk burning up the coil. I was going to put in a hidden toggle switch to combat the problem (also adds a little security). All the other lights and horn are wired through relays and function properly.