Posted by R. Rogers on Sunday, February 02, 2003 at 10:31PM :
I (my mechanic friend) swapped engines in my ffpw. From original 1950 230 ci, to later model, but still a 230. Anyway, the temp gauge fitting on the end of the coil will not fit into the head of the new engine. My mechanic rigged a contraption by screwing a device into the original hole in the end, then screwed the temp gauge fitting into this device. Unfortunately, I get no temp reading at all. Any ideas on how to remedy w/out changing heads? Also, any ideas (westach?) on later, more modern temp set ups? As always, any advice from the more learned forum members is appreciated.
Sincerely, R. Rogers
Follow Ups: