Posted by Dave Speed on Wednesday, January 15, 2003 at 10:12PM :
In Reply to: Is the winch drive shaft solid or hollow? posted by Tim Way on Wednesday, January 15, 2003 at 9:53PM :
Tim -
I've seen them both ways.
The one I plan (hope) to use is solid w a 0.250 groove milled into it. It was rusted solid when my Dad picked it up in Meadville, PA but I got it freed up in pretty short order.
FWIW, I bolted on my home-made frame extensions Saturday. Looking good.
I also have a half of a tubular setup that you're welcome to.
Dave