Posted by Andrew Walak [173.245.52.196] on Thursday, July 02, 2020 at 07:17:47 :
In Reply to: 53 M37, changing points posted by Jim DeWolfe [162.158.74.110] on Wednesday, July 01, 2020 at 19:58:49 :
1. Remove the distributor cap.
2. Remove the rotor
3. Remove the condenser
Sometimes you can get in there a remove the screws holding the points in place, but it may be easier to remove the two screws that are on the outside of the distributor and take the entire plate off if its tight.
Either way you should be able to remove the screw that secures the points to the plate and replace them.
Make sure you set the correct gap with the adjustment screw before starting it up.
Follow Ups: