Posted by Bob C. on Wednesday, January 02, 2002 at 10:18AM :
In Reply to: Hey Vaughn...Oil Pressure Relief Spring Shim posted by Fred Darvill on Tuesday, January 01, 2002 at 4:54PM :
I may have the same problem and I am wondering if a possible solution would be...
Can you replace all the insert and plasticgage them to see if you have reduced the spacing gap???? Or is it possible to get insert bearing for the Flatheads that are .001 to .003 oversize to compensate for journal wear?
Thanks for the advice.
Bob C.