WM300 Front Axle (Chrysler F375) Bushings

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Glenn [108.162.216.237] on Wednesday, January 29, 2020 at 14:59:56 :

Guys,
I am preparing to rebuild both knuckles and figure i would just rebuild the entire axle ends. Are there any tricks to pulling the inner drive shaft bushing and outer steering knuckle bushing when I rebuild the steering knuckles. VPW sell a $200 tool but that seems a bit much?

Also when i am doing the knuckle rebuild i plan on replacing all bearing sets, seals, and doing a break job. Do you recommend replacing tie rods prematurely too since i have it all apart?

Thanks
Glenn




Follow Ups:


Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


(1) Type your Message (2) Load New Code (3) Type new code into box. (4) Click "Post Message" button