Posted by Vaughn [172.68.150.109] on Monday, February 11, 2019 at 12:17:04 :
In Reply to: axle bushings and seals posted by Don in MD [162.158.142.109] on Monday, February 11, 2019 at 08:43:21 :
Look at the bottom of the page and you'll the the bushing puller. You can make one using a long threaded rod, nut & washers on one end, and a piece of flat stock. Drill a hole in the flat stock, then move the drill side to side to create a elongated hole so it will slip sideways through the bushing. Use a piece of wood on the trunnion with a hole and washers and nuts to hold the rod from turning while turning a nut against the wood. Hope you get the picture. When you install the seal and bushing, drive the seal and bushing in together to keep the seal from deforming.