Nut's removed, how to pull off the yoke?

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Jim Lee [162.158.106.87] on Thursday, September 13, 2018 at 15:56:40 :

In Reply to: Old leather seals. posted by Jim Lee [108.162.246.20] on Tuesday, September 11, 2018 at 19:16:46 :

I was able to finally get the nut off that holds on the Yoke.

I'm not able to get the yoke to budge. I've gone as far as to replace the U-Joint loops, pass a cross shaft through them then hammer a wedge between the cross shaft and the end of the pinion shaft. But I'm not comfortable bashing this very hard because I don't want to hurt the bearings inside.

I would think this would just slide off by hand, so I'm wondering if I've missed something here. Do I need to setup a puller for this? If so, I can't figure how.

I'm sure someone's been here before. Any hints?

Thanks!

-jim lee


Follow Ups:


Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


(1) Type your Message (2) Load New Code (3) Type new code into box. (4) Click "Post Message" button