Posted by Dan Shockley on Friday, November 02, 2001 at 4:08PM :
In Reply to: same splines posted by Don Scott on Friday, November 02, 2001 at 3:59PM :
There would be no problem using two different u-joints on the same shaft. The only problem could be that by interchanging the parts of the two shafts, you may wind up with a shaft that is out of balance. The only reason that you never see two differnt u-joints on the same shaft is that in design it does not make sense to have two differently rated ujoints when they will always have the same load in them.
Dan
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |