Posted by WarEagle [172.68.79.12] on Thursday, November 10, 2016 at 08:30:12 :
I'm 3/4 way around. Made some progress by siliconing inside edge corner of canal and securing canvas with pegs until dry. Then cutting outside edge of canvas off. Then placing rubber into canal with duck tail first. Then with flat head screw driver push tappered edge into at about 1 1/4 inch long and then tamping in the rubber on top with small hammer. Doing this I worked my way down one whole length of roof in about 30 miutes. Hope this helps
Follow Ups: