Posted by wayneh [173.245.54.71] on Wednesday, July 13, 2016 at 17:07:50 :
In Reply to: O.T. How to enlarge a large hole slightly? posted by Sherman in Idaho [108.162.245.23] on Wednesday, July 13, 2016 at 11:59:54 :
That is easy as pie for an automotive machine shop. Assuming they can mount it on the cylinder hone it is just not a lot of drama. My engine we didn't bore. We simply honed it 7 mils so it was an even 30 over all around. The hone I'm talking about is not the cheap brake cylinder hone, it is a three phase machine and if a block breaks loose when honing major breakage happens. See picture. (I hope..)
Wayne