Made my bracket and rod today


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Willy-N [72.168.160.211] on Thursday, December 10, 2015 at 20:23:59 :

Made my brackets for the power brakes arm. Welded up the 2-arms into one and put a small flat bar on the end to slide on the bearing. Made up the bracket that holds the bearing to pivot on and I can now bolt it to the frame. I can C-Clamp it in place to put it in the right place and test it first. I also made the rod up of 1/2" ID steel pipe and welded a nut on one end and a tab on the other. I have 1 1/2" of adjustment on the rod and drilled out the bar that drops down. I put 3 holes in it so I have several places to set it for the right ratio. Should work good and they are drying right now in my shop after painting them.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com