Check surfaces for flat with a piece of glass?


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Chris Case [108.225.239.175] on Sunday, October 04, 2015 at 15:14:51 :

In Reply to: Heat riser leak! posted by Sherman in Idaho [50.120.88.57] on Sunday, October 04, 2015 at 12:56:02 :

Ink a flat surface with a felt tip. Maybe a rear view mirror? Table saw surface? Place against the gasket surface and rub a bit. Grind and file a bit where the ink transfered. re-ink. repeat. You could use carbon paper instead if felt tip, if you can find any.

On soft materials, and using a scraper, once you get 50% ink transfer by surface area you are about 1/2 of a thousand flat. You only need the surfaces to mate within ummm.010"? Easy.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com