Re:Close Up of Bearing Mount Picture

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Willy-N [72.171.192.62] on Thursday, August 27, 2015 at 12:53:26 :

In Reply to: Re: OT Rattle Snake Bit for a Picture??? posted by Daryl in Oz [211.27.75.101] on Thursday, August 27, 2015 at 03:05:36 :

Here is a close up of the bearing support. I used a set of M37 Lifting eyes that they sling M37s using 4 of them. It is bolted with the same bolt pattern and a grade 8 bolt thru them one bearing on each side just like the old clevis did. I will remove this bolt and run it thru the side plates and double nut it plus drop one to the frame off the end. These bearings are bolted tight together no movement except rotation on the bolt.

You Tube Video of the story.

Follow Ups:

Re:1 1/8" Pillow Bearing Specs - Willy-N 13:19:52 08/27/2015

Re:1 1/8" Pillow Bearing Specs - Daryl in Oz 18:24:14 08/27/2015
- Re:1 1/8" Pillow Bearing Specs - Willy-N 20:45:04 08/27/2015

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com