Posted by Peter Hewko on Wednesday, August 08, 2001 at 3:46PM :
In Reply to: Attention 273-318LA RKI's - NEED HELP!!! posted by Brian in Oregon on Tuesday, August 07, 2001 at 11:56AM :
I don't have the same crank, but what I ended up with for pulleys was a '80 three groove crank pulley, large diam deep single groove water pump pulley (almost touches the crank pulley), '80 two groove alt and '80 PS pump and bracket. Belts run crank-water pump-alt and crank-PS-alt. The '80 PS pump will fit with stock brackets if the washer and top rubber mount (Helitool kit) are ground down a bit. Also, I had heard that using the water pump from a 360 powered Dodge van would put the fan in the center of the stock shroud. Anyone know more about this?
-Peter Hewko
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |