am I the only one who doesn't know this?

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by wayneh [68.48.213.51] on Wednesday, January 07, 2015 at 19:54:03 :

So the last time I pulled the NP420 and replaced the clutch I had a spare input shaft hanging around that I used as a clutch alignment tool. That NP420 is now back together, and I'm not motivated to pull it apart just to use the input shaft as an alignment tool. So I looked around on the internet and at first nothing came up, but then I saw an ad for a company called "clutchtools.com". I wasn't very optimistic, but I did find a tool that appeared like it had 10 splines on a 1" shaft with a 3/4" pilot bushing. For ten bucks I clicked on the link. A few days later the CP10 Clutch alignment tool shows up in the mail. I head out to the garage to check it out, and sure enough it is perfect! So if anyone else likes to use a clutch alignment tool when bolting down the pressure plate, this looks like the ticket and it is inexpensive.

Wayne


Follow Ups:


Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com