Posted by Kaegi [98.247.164.246] on Monday, May 19, 2014 at 21:44:55 :
In Reply to: Re: be afarid posted by Gil H. Ingram [139.55.33.0] on Monday, May 19, 2014 at 21:06:58 :
you will need a depth gauge so you dont drive them in too far and there is a special tool for driving them in but I have dont it with a big brass punch. then you may need a set of reamers to size the guides correctly to each valve.
just an FYI The etiquette on this forum is not to start a new thread over and over again on the same topic. just ask the related questions iunder the origianl post. Tons of knowledgable guys are reading
Follow Ups: