Surface Prep Before Primer

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Rick [67.188.186.65] on Saturday, December 14, 2013 at 11:12:40 :

I've had some of my parts (e.g., the transfer case housing) glass beaded to clean them up. The parts have to be washed thoroughly to remove any residual grit; however, after washing and blowing off any moisture you get that orange-brown haze of flash rust. I'm using a good epoxy primer, so my question is whether the flash rust is anything to worry about. I've tried some phosphoric acid based rinses in the past, but I always worry about getting the surface neutralized afterward and sometimes they seem to leave a slightly sticky surface. Any suggestions?

Follow Ups:

Re: Surface Prep Before Primer - chris irick 22:36:37 12/21/2013

Re: Surface Prep Before Primer - Marty 00:27:53 12/15/2013

Re: Surface Prep Before Primer - Todd in Kansas 10:02:43 12/15/2013
- Sorry Todd.... - Marty 13:34:38 12/15/2013

Re: Surface Prep Before Primer - JohnD 17:25:01 12/14/2013

Re: Surface Prep Before Primer - gmharris 12:13:27 12/14/2013

Re: Surface Prep Before Primer - Sherman in Idaho 11:50:47 12/14/2013

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com