Posted by CREEPING DEATH on Friday, June 01, 2001 at 0:23AM :
In Reply to: flathead rebuild tips? posted by charlie on Thursday, May 31, 2001 at 8:58PM :
Grind the ports to the same size, if you check you'll likely find that they're not even close due to the primitive casting tehnology of the time. If you port-match the block and manifolds, you'll free up a little power that was there but hiding, it won't add stress to the engine like upping the cam or compression will.
JB
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |