Posted by Clint Dixon on Friday, April 13, 2001 at 1:50AM :
In Reply to: will late series synchromesh tranny, 1957 flat fender posted by eric on Thursday, April 12, 2001 at 9:25PM :
All 1946 to 1968 WDX-WM300 factory equipped with front winch and/or rear tail shaft used a dual output pto (front and rear outputs on same pto). In other words, with a factory pto no reversal required because they are set up to be used either way, front or back, and even to both directions at once. If you are referring to an after market pto with a single output shaft, some can be reversed, some cannot. Factory pto's very between the different trannys used. Best to use the one meant for a given transmission although if you absolutly need to, pto gears can be changed and spacers used.
|
Follow Ups:
This board is powered by the Mr. Fong Device from Cyberarmy.com |