Posted by Kaegi [24.16.253.154] on Friday, April 13, 2012 at 12:02:14 :
In Reply to: It was the contact points!! posted by Glen Id [72.173.87.91] on Friday, April 13, 2012 at 10:54:12 :
good find! I bought an NOS 318 dist a few years ago and it would start to run porrly when warm and did not want to start when hot. it turned out to be the points were over tightened and as it warmed up the bottom part would warp a bit throwing the points into bad alignment. I had to use alot of strength just to break the screw loose!