Posted by Russ on Friday, January 12, 2001 at 9:17PM :
In Reply to: Wheel bearing removal on 78, Stuck??? posted by Anthony 78PW on Friday, January 12, 2001 at 6:46PM :
If you have a dremel tool, try to carefully cut a slot in the ring with a small abrasive disk. If you don't go all the way through the ring, you usually can use a cold chisel to break through the rest of the way. This will relieve the pressure to allow the ring to pop out easier. Good luck.
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |