Posted by Dan Shockley on Friday, January 05, 2001 at 12:50PM :
In Reply to: Cut-off wheel setup for 4 1/2" grinder? posted by Joe Cimoch on Thursday, January 04, 2001 at 5:25PM :
Find a Milwaukee dealer. Buy a set of their hub and lock nut. They are the only type I will use. They will work with 1/4" or 1/8" wheel and flat or dished wheels. They are also small diameter so they allow full use of the wheel. The last set I bought were about $10.
Anyone that has any brand of 4 1/2" grinder should buy a set of these. They will work on any grinder. I use them on both of my Dewalts.
Good luck
Dan
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |