Posted by Dwight in N.TX. on Thursday, January 04, 2001 at 5:39PM :
In Reply to: Cut-off wheel setup for 4 1/2" grinder? posted by Joe Cimoch on Thursday, January 04, 2001 at 5:25PM :
I USE THE WORN OUT BLADES FROM MY CHOP SAW(14" MAKITA). THEY END UP BEING ABOUT 7" DIAMETER WHEN I PULL THEM OFF. I HAD TO REMOVE THE GAURD ON MY ANGLE GRINDER TO USE THEM , SO THERE IS NOTHING BETWEEN MY HANDS AND THE BLADE EXCEPT A GOOD THICK PAIR OF GLOVES. I TRY NOT TO USE THIS SET-UP UNLESSS I ABSOLUTELY HAVE TO. TRY A TORCH OR JIGSAW FIRST THEY BOTH WORK WELL RESPECTIVELY.
DWIGHT
This board is powered by the Mr. Fong Device from Cyberarmy.com |