|
|
Posted by Bruce in BC [24.207.16.216] on Thursday, August 12, 2010 at 23:30:21 :
In Reply to: Yes you can remove the flex plate posted by Bruce in BC [24.207.16.216] on Thursday, August 12, 2010 at 19:20:19 :
the replacement flexplate popped in quicker than the old one did when I had to wiggle it out . Lining up the trannie was a breeze - I simply replaced each bolt with one a bit longer as I pulled the old bolts bout . I then slid the trans back about 1 inch . I used 6 bolts instead of the standard 2 to keep things in alignment and not sag . Blocked up the motor under the pan and dropped the starter . All the linkages and driveshafts remained hooked up .
Worked slick
Bruce
Back to the Carryall tomorrow
Follow Ups: