|
|
Posted by David Sherman [24.32.202.83] on Friday, December 04, 2009 at 19:15:02 :
In Reply to: Re: Thanks for the picture posted by Jerry in Idaho [64.139.238.43] on Friday, December 04, 2009 at 18:07:30 :
Did you fabricate the whole arm, or just the bracket? Either way it looks really good. I do not have the bracket. The bolts that held it are broken off flush with the housing. Since this is my ugly truck, I'll probably just drill and tap new holes rather than try to get the broken stubs out -- unless they stick far enough into the inside that I can grab them with vise-grips.
A rough sketch that just shows the dimensions of things would be really helpful. First I have to tear apart and overhaul what I have, and I have to turn the PTO around and get a drive shaft for it, but as long as I'm working on this winter project, it would be nice to make a clutch handle for it too.
Follow Ups: