Posted by bruce in BC [24.207.96.230] on Thursday, September 03, 2009 at 18:12:18 :
In Reply to: Crossmember thoughts posted by Desoto61 [72.218.216.61] on Thursday, September 03, 2009 at 17:24:03 :
I would use cold rolled steel.
(1) cut out the pieces
(2) spray what will be the inside with zinc weld through primer .
(3) Tack it up and test fit . Jump around with the welds .
(4) Finish welding.
(5) tape up all the holes but one , pour in some paint and slosh it around
(6) let dry and install
Bruce
Paint the outside when the welding is done