Posted by Chriscase on Monday, February 09, 2009 at 19:55:07 :
In Reply to: bed question, concerning the hat channels posted by Doc Dave on Monday, February 09, 2009 at 18:11:58 :
I welded and re-drilled one hole on each side. Making a round hole square is not to hard, use a small tri-corner file.
But it's been a couple years now, I don't recall which holes. Not all of them, or maybe I did heve my side pieces reversed?
I did make the mistake by welding the three piece angle strips together, then had to tortue them to get them lined up later.
Follow Ups: