|
|
Posted by Tom Petroff (IL) on Monday, December 29, 2008 at 17:46:12 :
In Reply to: Electrical Questions posted by Sam on Monday, December 29, 2008 at 16:18:09 :
Sam,
STOP STOP
copy&paste Paul's link and do some serious reading.
Before you go any farther.
I don't see any ballast resistor on the coil,which will melt the points,
The battery wire on the Alt. should go through the amp gauge then to the battery.
The diode Vaughn it referring to goes between the ing. wire at the coil to the I terminal,
Then another jumper wire between the batt terminal and the other blade terminal.
Look in the PIF at top of page. He has a diagram there too.
TGP