|
|
Posted by chriscase@san diego on Sunday, April 06, 2008 at 01:39:26 :
In Reply to: Heater Hose T - Chris Case posted by Todd Wilson on Sunday, April 06, 2008 at 00:37:04 :
But you just described it to a TEE.
The photo in my mind has an octagonal bent washer on the out side, plus a thin nut to tighten it all together. Probably only good for low pressure applications. I had put mine into the top radiator hose.
But I believe that the Plymouth's used a fitting brazed into the lower steel tube elbow. The fitting you have was the generic replacement for the factory Plymouth part.
Far as I know, the trucks all used an elbow at the top of the water pump.
Try a Plymouth site er two, for a repro lower tube with tee?
Follow Ups: