|
|
Posted by Roger in La on Monday, February 25, 2008 at 18:50:47 :
In Reply to: Help locating fuel tank filler. posted by Glen Idaho on Monday, February 25, 2008 at 00:09:21 :
Glen, i had the same problem with my 3rd series, which i think is a different length. My bed was custom from the factory, apparently with the fuel tank in another place so never had a hole.
A couple people measured theirs for me then I took careful measurements myself. They took measurements horizontally from the rear stake pocket and diagonally from the center of the grease fitting hole in the bed.
I ended up with three center marks all within a 1/4" or so of each other, interpolated the center of these three, and cut the hole. It worked fine. You do have a little play with the rubber connector to the tank.
If you search the archives from on on few forums back, you should find it but the info will be for 3rd series beds.
Roger