Winch INPUT shaft.

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by chriscase on Thursday, September 20, 2007 at 11:46:51 :

In Reply to: I think its for a set screw posted by mannyc on Thursday, September 20, 2007 at 10:13:20 :

That is where the threaded hole is. Yes, there are other set screws on the assembly. But why a set screw there? A set screw would just bugger up the shaft if the shear pin shears.

There is NO key way cut in that yoke, so why thread a hole that wouldn't be used either?

Checking the threads like Dave said is easy enough. And maybe I'll put a zerk in anyhow- a yoke that is rusted to it's shaft sorta negates the idea of the shear pin.

Follow Ups:

it IS for a grease zerk - Clint Dixon 12:31:03 09/20/2007

Yup, turned out to be 1/4". - chriscase 16:34:55 09/20/2007

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com