I think its for a set screw

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by mannyc on Thursday, September 20, 2007 at 10:13:20 :

In Reply to: Zerk fitting at shear pin? posted by chriscase on Wednesday, September 19, 2007 at 23:18:38 :

if i am correct (based on the m37) the hole is for a set screw to hold the yoke on the shaft. the shaft is keyed and the set screw holds the assembly tight. The shear pin is on the winch output shaft and is held in with a cotter pin. Correct??

mannyc

Follow Ups:

Winch INPUT shaft. - chriscase 11:46:51 09/20/2007

it IS for a grease zerk - Clint Dixon 12:31:03 09/20/2007
- Yup, turned out to be 1/4". - chriscase 16:34:55 09/20/2007

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com