Re: Drive Line Angle


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by MoparNorm on Tuesday, July 10, 2007 at 01:24:51 :

In Reply to: Drive Line Angle posted by Joe Cimoch on Monday, July 09, 2007 at 21:26:48 :

I'm not sure what I'm looking at, but the control point is this:
Centerline of engine crankshaft is the primary axis. If you have conventional u-joints (non-CV) then ALL components must share that centerline, regardless of location, in other words, all centerlines must be parallel within 2 degrees. Motor-transmission-transfer case and front and rear pinions, with the drive line angle no greater than 6-9 degrees from those centerlines.




Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com