Posted by Dylan Robinson on Wednesday, February 14, 2007 at 17:31:28 :
In Reply to: Re: Ideas posted by Gary Troxel on Wednesday, February 14, 2007 at 17:17:01 :
Okay so here is a question. I have access to a lathe a and a milling machine. I have just enough Know-how to get me into trouble most of the time. How exactly is the best way to do a one time production run of said axle shafts. I would have tried this before but the way I understood it these splines had to be "rolled on". I could cut the blank and send it off to be splined and hardened. If it were to be one a one piece unit that would be a lot of scrap. Thinking out loud I guess.
thanx in advance for ideas!!
Dylan