Posted by 55dodge230 on Thursday, January 25, 2007 at 11:38:43 :
I think i may have screwed up. I just got my 230 dodge engine back from Napa. They sealed all the outside oil passages up with plugs. In an attemp to remove the small 1/8 inch oil line plug, I stripped it out. So I then drilled it out but I think I drill thought the block. I haven't pulled the pan yet to confirm but the bit goes all the way in. Duh. As homer would say. If this is so any ideas on a fix? JB weld, welding. I still have to drill out the other one. Damn soft metal plugs. Thanks in advance
Follow Ups: