Posted by Tim Holloway on Thursday, November 23, 2006 at 10:36PM :
Going to put the transfer case back in the Power Wagon tomorrow using new rubbers. Just curious how tight to tighten the bolts that go through them. I assume that they get tightened until the sleeve that the bolt goes through snugs up to the round plates.
The other question is probably a 50 50 thing. Is it easier to bolt the cast mounting brackets to the transfer case and install them as a single unit, or is it better to hang the mounting plates and then slip the transfer case up between them and then bolt them together? I think either way would work, and I have done the second way.
Thanks,
Tim
Follow Ups: