Posted by Vaughn on Tuesday, October 18, 2005 at 8:32PM :
In Reply to: Overheating posted by Scott R on Tuesday, October 18, 2005 at 11:18AM :
- STD cylinder bore or oversized?
- Check vacum advance and make sure it works
- Check timimg
- If you are using the stock PW radiator, lower the water a little below the bottom end of the filler tube and watch for air bubbles while the engine is idling
- Did the machine shop check for cracks in the cylinder heads? Were cracks repaired?
- Is this engine from a salvage yard?
- New water pump or rebuilt?
- Radiator cleaned?
A lot of questions but helps determine what might be the problem
Follow Ups: