|
|
Posted by Glen Culdesac Idaho on Saturday, September 13, 2008 at 23:12:36 :
In Reply to: drilling rivets and pulling the crossmembers posted by Tim on Saturday, September 13, 2008 at 16:56:03 :
Tim, If you do it you are getting some good advise. The way I did some of mine was to use a 4 1/2" grinder carefully grind off the head, center punch and drill a shollow hole that your air punch will fit in and hit the trigger. I also machined a bore in a length of shafting to use as a buck on the off side and they were out in no time. Good luck