Search the Power Wagon Forum Archives Add T137 Archives Search to your Browser


Limit search to:
Sort by:
 Results for centered rear axle   441 to 460 of 539 results. Run time: 0.034 seconds | Search time: 0.006 seconds    
 Page:1 18 19 20 21 22 23 24 25 26 27 Previous 20 Next 20
441 Will -- rank: 201
... constant EC upgrades I will make more progress ha ha. Centered rear axle housing in place, Cummins mounted in test stand for check ...
Last Modified Date: 2005-08-31 00:00:01 CDT
Document Size: 5666
Document Path: ../archives/wwwboard183/messages/1830826.html
442 Help -- rank: 201
... did new with about three inches of travel between the axle and the rubber stops. Now when I hit about 40 ... tons the center bolt on the front springs is to centered. Can somebody check to see which way that go on ... be sure to reinstall them with longer side to the rear. Help Thanks Dave Follow Ups: Re: Help - Arizona Steve 3 ...
Last Modified Date: 2003-05-05 00:00:01 CDT
Document Size: 7930
Document Path: ../archives/wwwboard101/messages/1011029.html
443 If it was closer to Connecticut, I'd buy it.. ntxt -- rank: 201
... Saturday, September 17, 2005 at 12:39PM : In Reply to: Centered Rear Axle $15 1 Day left to Bid posted by Vaughn on ...
Last Modified Date: 2005-09-28 00:00:01 CDT
Document Size: 5080
Document Path: ../archives/wwwboard185/messages/1850097.html
444 Engines and parts for sale.... -- rank: 201
... steel flatbed with ironwood decking, WDX-WM300 axles, WC 52 centered rear axle. Passender side WDX Doors, PW firetruck equipment (6v federal siren ...
Last Modified Date: 2005-01-23 00:00:01 CST
Document Size: 5536
Document Path: ../archives/wwwboard164/messages/1640298.html
445 Don't blame me..... -- rank: 201
... cab(I had to modify the cab). I like your axle setup. Your one up on me there. I'm already ... to at least start out with the WC axles. The rear is centered that should help lessen breakage problems. I always liked the ...
Last Modified Date: 2005-06-26 00:00:01 CDT
Document Size: 6147
Document Path: ../archives/wwwboard178/messages/1780883.html
446 Parts wanted...... -- rank: 201
... apx. 4.5" across. This is to finish up a centered rear axle swap. I also need 6 corner bows for a canvas ...
Last Modified Date: 2004-08-03 00:00:01 CDT
Document Size: 5241
Document Path: ../archives/wwwboard146/messages/1460125.html
447 Re: Carter Ball and Ball or W1?? -- rank: 201
... or an SM465 with a NP203/205 doubler and a centered rear axle.....but until then, I have to keep it running! :-) Thanks ...
Last Modified Date: 2005-10-21 00:00:01 CDT
Document Size: 5364
Document Path: ../archives/wwwboard187/messages/1870179.html
448 It runs great! -- rank: 201
... 160 HP (Hemi) vs 89 HP (flathead). I have a centered differential rear axle, and a set of 4.89's for it. Also ...
Last Modified Date: 2003-12-26 00:00:01 CST
Document Size: 6480
Document Path: ../archives/wwwboard123/messages/1230777.html
449 Yea Todd, you cheap ass.. -- rank: 201
... and Bellhousing (that's not in the truck), and the centered rear axle for the power wagon, and I'm the one who ...
Last Modified Date: 2004-09-23 00:00:01 CDT
Document Size: 5406
Document Path: ../archives/wwwboard151/messages/1510379.html
450 Repower Kit for WDX-WM300 Power Wagon -- rank: 201
... to run a Braden MU2 winch. I also have a centered rear differential for the WDX-WM300 power wagon to cut down ... also. I'm asking $1000 for the engine, trans, and axle. $300 for the NP 205. Anything else off the truck ...
Last Modified Date: 2004-09-23 00:00:01 CDT
Document Size: 7232
Document Path: ../archives/wwwboard151/messages/1510351.html
451 "bending in two directions" HA HA HA HA -- rank: 201
... December 17, 2003 at 11:56AM : In Reply to: Re: Centered t-case output with stock rear axle posted by Dan Lowe on Tuesday, December 16, 2003 at ...
Last Modified Date: 2003-12-26 00:00:01 CST
Document Size: 5797
Document Path: ../archives/wwwboard123/messages/1230298.html
452 Longer shaft more flexible? -- rank: 201
... 48in shaft could handle about 10 degrees...thats about a rear shaft from offset axle to centered transfer case...Well, that answers that question- to some of ...
Last Modified Date: 2005-01-06 00:00:01 CST
Document Size: 5590
Document Path: ../archives/wwwboard162/messages/1620088.html
453 Frank . . . -- rank: 201
... You would't happen to have WC 3/4 ton axle shafts? If so, email me. I'm looking into swapping a centered WC rear into my M37. BTW: I finished my Ben Hur trailer ...
Last Modified Date: 2003-09-07 00:00:01 CDT
Document Size: 5356
Document Path: ../archives/wwwboard113/messages/1130901.html
454 WF-62 -- rank: 201
... FFPW. The question i have is the 13.000 lb rear axle would look pretty neat under my FFPW,it would be centered and has bigger axles for the V-8 swap. Dimentions ...
Last Modified Date: 2005-02-06 00:00:01 CST
Document Size: 5075
Document Path: ../archives/wwwboard166/messages/1660120.html
455 Whatdaya think??? -- rank: 201
... on those motors can get quite expensive. I have a centered rear axle and a set of 4.89 gears. The v8 may ...
Last Modified Date: 2003-07-04 00:00:01 CDT
Document Size: 9817
Document Path: ../archives/wwwboard107/messages/1070207.html
456 Hey Eric B, would you run some numbers? -- rank: 201
... 2 ton front sheetmetal, 15" wheels, single speed transfer case, centered rear axle, bumperettes and a pintle. My thinking is its a 1 ...
Last Modified Date: 2006-02-09 00:00:01 CST
Document Size: 7403
Document Path: ../archives/wwwboard197/messages/1970399.html
457 Paul.... -- rank: 201
... looking for a better set up to go with my centered rear axle set-up and like the looks of what you've ...
Last Modified Date: 2004-05-22 00:00:01 CDT
Document Size: 5989
Document Path: ../archives/wwwboard139/messages/1390531.html
458 Re: V-8 auto swap -- rank: 201
... t remember if the 1/2 ton WC used the centered rear axle, but if it did, I would use a married t ...
Last Modified Date: 2005-01-30 00:00:01 CST
Document Size: 5997
Document Path: ../archives/wwwboard165/messages/1650268.html
459 Engine swap for the Crew Cab... -- rank: 201
... transmission that's in the crewcab. I also have a centered rear differential axle and a set of 4.89 gears available already installed ...
Last Modified Date: 2004-01-31 00:00:01 CST
Document Size: 5352
Document Path: ../archives/wwwboard127/messages/1271105.html
460 Dent Factor. -- rank: 201
... FFPPW With no engine or trans, take and put a centered rear axle in it, 4.89 gears, Power Disk Brakes all around ...
Last Modified Date: 2004-01-14 00:00:01 CST
Document Size: 6038
Document Path: ../archives/wwwboard125/messages/1250837.html
 Page:1 18 19 20 21 22 23 24 25 26 27 Previous 20 Next 20