Re: Gasket around Wind Sheild and others?


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Vaughn on Sunday, April 13, 2003 at 12:51PM :

In Reply to: Gasket around Wind Sheild and others? posted by Willy-N on Sunday, April 13, 2003 at 11:07AM :

The later outter rubber seal for the windshield is now a one piece

Window sweeper. Should use clips to apply. Use ½ to 9/16ths wide, 15 inches per door. You need the rubber window bumpers, there are slots in door inside Panel Glass side at bottom of window opening.

Window channel. There are clips that hold the WC. You can use silicon seal (spaced) between channel and door to hold channel in place. Use 5/8thsx5/8ths channel, but put window ventilator in first to measure length needed from it to the stop located at back side of door half way down or so.

Ventilator Window Division Bar - Use Mohair Channel Liner to replace mohair on Ventilator Window Division Bar. Apply contact cement prior to applying mohair.

The long front adjusting bar that has window channel in it plus MoHair can be taken apart and religned with MoHair an new channel.

Also look to see if you have the top and bottom bakelite black bumpers for adjusting the doors. They are towards back of door their are two screw holes where they mount.

Also need the two side door bumpers that mount to cab on each side.

Cowl Vent Rubber - 3.5”Wx18”L (Correct size)

That's all it can think of at this point.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com